If you’re new to snorkeling or have recently upgraded to a full face snorkel mask, knowing how to put it on properly is essential for a safe and enjoyable underwater experience. Unlike traditional snorkel gear, a full face mask covers your entire face and includes a built-in snorkel, allowing you to breathe naturally through your nose and mouth. But to enjoy all its benefits, it must be worn correctly.
Here’s a step-by-step guide to help you put on your full face snorkel mask the right way.
Step 1: Choose the Right Size
Before anything else, make sure your mask is the right size for your face. Most brands offer size guides based on the distance between your chin and the bridge of your nose.
If the mask is too small, you may feel tight and cause discomfort.
If the mask is too large, you risk water leaking in during use.
Always test the fit at home before heading to the water.
Step 2: Check the Mask
Check the mask for any cracks, loose parts, or sand trapped in the seal.
Ensure the snorkel tube is firmly connected (some models require attaching the snorkel manually).
Check the straps for smooth adjustment and no tangles.
A quick rinse with fresh water before use can also help prevent fogging.
Step 3: Position the Mask on Your Face
Hold the mask with both hands, keeping the snorkel tube upright.
Place your chin into the bottom of the mask first.
Gently pull the mask over your face, pressing it down to create a seal.
Make sure your nose and mouth are fully enclosed in the inner breathing chamber.
Step 4: Adjust the Straps
Pull the elastic head straps over the back of your head.
Tighten the straps evenly on both sides until the mask fits snugly.
Don’t over-tighten—this can cause discomfort and may actually break the seal.
The mask should feel secure but not press too hard on your face.
Step 5: Check the Seal
To test the seal:
Breathe in gently and see if the mask suctions slightly to your face.
If air leaks or you feel gaps, reposition the mask and adjust the straps.
Do a leak test by submerging your face briefly in water. No bubbles or water inside? You're good to go!
Step 6: Practice Breathing
Before heading into deeper water:
Take a few deep breaths while keeping your face in the water.
Practice turning your head side to side and looking down.
Get used to the airflow system—there may be a slight resistance at first.
If breathing feels difficult or water enters, recheck the fit and snorkel connection.
Step 7: Enter the Water Slowly
Start in calm, shallow water. Move gently and avoid diving or quick head movements until you're fully comfortable. Full face snorkel masks are designed for surface snorkeling only, not diving.
Leak- resistant guide from Greatever brand
1. Wearing
Hold the lower edge of the mask and align with face.
2. Securing
Pull the head strap backward over the ears.
3. Fixing
Chin gap? Replace for a proper fit.
4. Testing
Press the mask against your face and inhale sharply for 3 seconds to check seal.
5. Adjusting
Hook the straps with index fingers and Iift alternately to temple position
6. Confirming
Turn head 30°left/right and smile to verify no leaks at edges.
Tips for a Comfortable Fit
Avoid wearing the mask over hair or swim caps—this can cause leaks.
Tie back long hair to prevent it from getting caught in the seal.
Do not use with a beard—facial hair can interfere with the seal and cause leaks.
Rinse the mask after each use to remove salt, sand, and debris.
Wearing a full face snorkel mask properly is key to enjoying your underwater adventure safely and comfortably. From choosing the right size to adjusting the fit and testing the seal, each step ensures you get the best experience possible. With the right technique, you’ll be gliding through the water with ease—taking in the sights and breathing naturally every step of the way.
Explore Greatever G2 full face snorkeling mask here.